Vacuum glass lifters meet different requirements of rigid and flexible design

Vacuum glass lifters are divided into rigid and flexible glass lifters. Different glass lifters have different design ideas and structures. Therefore, they are suitable for the design of rigid vacuum glass lifters and flexible vacuum glass lifters in different situations.             

 1.  Sealing edge should be made of soft, tough, less wrinkle and non-destructive materials. The width of the sealing edge should be covered by the template.            

 2.  The glass lifter can move freely with the expansion and contraction of the clay during the spider journey of vacuum operation.            

 3.  The structure is simple, easy to repair and repair, easy to clean, durable.            

 4.  Light weight, easy to move and lay.            

 5.  It can adapt to the change of component size.            

 6.  Vacuum distribution is uniform, water flowing freely, and it is not easy to block and break the circuit.             

 7.  Good smoothness, firm bonding seam and low cost.             

 8.  The rigid vacuum glass lifter has certain rigidity and can withstand vacuum negative pressure and structural dead weight pressure.

 On weekdays, when we use vacuum glass lifter hook, we sometimes fall off. So what can we do to ensure that the vacuum glass lifter hook lasts longer? What maintenance work should be done well?            

 1.  Do not install the vacuum glass lifter hook on the concave, convex, rough and easily falling surface.            

 2.  The smoothness of the veneer surface is not the most important. The most important thing is absolutely not to breathe. It's like cracks in ceramic tiles. It's hard to stick firmly.             

 3.  When wiping the adsorbed surface, we should avoid scratching the surface of the product by hard objects, and never wipe it with coarse cloth.            

 4.  Do not hang heavy objects beyond the prescribed range after installation.            

 5.  Pay attention to the scale load-bearing of the vacuum glass lifter hook. Do not change the use and overweight use.            

 6.  Before use, wipe the adhesive surface with a clean soft cloth to make it fully dry.            

 7. Avoid washing hooks with alkali or boiling water to prevent damage to the paint surface.            

 8. Do not contact with organic solutions or corrosive chemicals or use them in gaseous environments with the above substances.            

 Only by doing a good job in maintaining the vacuum glass lifter hook can we ensure the safety of the object, so that we can be more assured in the use of the process.
 Vacuum glass lifter does not need vacuum pump, because vacuum glass lifter uses vacuum ejector, as long as it can run through the air compressor. Even if the cutting oil, cutting water and chips have been sucked into the machine, the vacuum glass lifter can discharge it out of the machine.           
 Any type of processed product can be fully operated:           
 Vacuum glass lifter can be used for upper layer processing, side processing, and grinding operations. With the use of metal sheet, it can be processed on the surface and side of a special shape object, and it can also easily complete the piercing operation.            

The size and size can be adjusted at will:           
 Change the assembly and adjust the body according to the size of the processed object. The platform can be set up according to the size and size of the processed object.            

 Keyway and operation scheduler settings:           
 There is a key groove high at the bottom of the body, so the vacuum glass lifter can obtain accurate parallelism and verticality when working side by side. Two operation stabilizers are installed on the side of the body to prevent the lateral impulse.