​Introduction to the structure and process of electronic floor scale

Introduction to the structure and process of electronic floor scale
Unique U - shaped steel bridge structure

Car scale platform design for reference to the aircraft wing and golden gate bridge honeycomb structure principle, the design of the scale platform with high strength, good rigidity, compact structure and other characteristics, scale safety overload up to 150%, its design has the following characteristics:

1. In the shape of components, the span of fulcrum in the middle amplitude plate (stiffened plate) and longitudinal section has the greatest influence on the rigidity. In view of this, the company each section of the scale u-shaped main beam 5~7 heel, the height of the main beam 300mm-340mm, (according to the tonnage and the size of the table) to ensure the overall rigidity of the scale platform.

2. The company introduces the special u-shaped beam forming equipment, adopt u-shaped cross-section compound (fourth generation), component by special equipment manufacturing, good overall structure, high rigidity, this is the reason why weighing platform stronger stiffness, weighing platform inner cavity sealing, not easy to rust, steel plate after blasting derusting treatment, using epoxy USES epoxy zinc-rich primer and acrylic Marine paint, oil film thick, thickness of 100 microns, wear-resisting, compression, acid and alkali resistance, corrosion resistance stronger.

3. Modularization: it can be made into three modules of 5m/6m/7m, which can be randomly combined according to the size of the table to ensure the consistency of the products, which is easier for production organization and on-site installation and debugging.

4. Floor scale technical parameters:

Modularized, standardized and serialized weighing platform multi-unit combination, weighing  platform combination length :6-25m, customizable ※ weighing range 10-150t, standard table size width 3m or 3.4m, 3.6m Digital display of gross weight, net weight, tare weight, dynamic underload and overload.
Digital, automatic zero eye tracking, automatic peeling, automatic peeling, keyboard setting/correction※ car number, tare weight storage, item accumulation, total measurement.

Fault self-diagnosis function.
Construction instructions for weighbridge foundation:
Whether the floor scale is used normally or not after installation, one depends on the quality of the floor scale itself, and the other depends on the foundation of the floor scale.
So for you to install the foundation of the floor scale will put forward certain requirements, below we will simply analyze the uneven foundation of the floor scale will have what impact on the floor scale.
The installation of floor scale requires the foundation to be smooth, and the sensors on each scale are stressed evenly;
Otherwise, the Angle difference will be large and cannot be adjusted; Poor directional section, poor repeatability and other faults
Case 1: a digital truck scale (scs-150, platform 3) has serious Angle difference.
The  spot inspection found that the stress of the scale was not even, after the pad was leveled, the weight truck was pressed, and the Angle difference was about 200kg. Through the test inspection, it was found that the stress point had a very serious change.
Case 2: the digital truck scale (scs-100, platform 3) had a poor directionality segment, and the foundation was found uneven on the site, which resulted in the panel of the platform of two sections of scale was already dead. After the balance of the platform was adjusted by pad and balance, the balance was normal after the Angle was adjusted by axis, and the weight of the scale before and after was consistent.