Customer: For MD type electric wire rope hoist, 2T * 13M
Iron beam will be which size size
Do you have video for how install this
RAMHOIST:
Iron beam size: 20a-32c
pls check below installation procedures:
1st, measure the width of the bottom of the I-beam
2nd, Add gear oil to the gearbox
there are instructions on the chart for how much to add
3nd, use suspension shaft to connect electric trolley with electric hoist
Now, the electric trolley is already installated over.
Let's talk about the precautions below for installation
The main electric trolley, the electric trolley with motor need to install
on the side of fire break limiter
The 4 washers inside the electric trolley must be consistent everywhere
The inner diameter of the outer edge of the electric trolley's wheel is 2-3mm larger than the width of the bottom I-beam just measured
4th, the electric wire rope hoist is installed on the I beam
Now, the electric wire rope hoist is installed over.
- No information
-
Customer: For MD type electric wire rope hoist, 2T * 13MIron beam will be which size size Do you have video for how insta…
-
1. Design objective of electronic crane scale network management. (1) Adopt advanced distributed data processing techno…
-
Electronic crane scale bearing platform installation to focus Electronic crane scale can be installed generally on the li…