How to avoid the wobble of electric hoist running

Keyword:electric hoist   Time:2018-11-26 22:53:00

How to avoid the wobble of electric hoist running
 When the electric hoist is running on the I-beam, it is easy to shake the object. How can we solve this problem? Please answer below
 This should not be too far away from the distance between the ends of the electric hoist. If the fixture is too far away, it can not be installed in the middle. The lifting load is not allowed to run near the end of the beam. Lifting the load shock will touch people and things or fall down. The cause of this serious accident is like death or serious injury. If the load is shaken, the more powerful the vibration, the more difficult the lift car will run, and the more dangerous it will be. In principle, do not sloshing the load horizontally. Therefore, please follow the following points.
 Do not pull down
 The horizontal movement makes it slow to start
 Do not lift the load quickly
 If the lateral movement of the chain crane is lifted and stopped, the lifting load  will be shaken even after the above operation. At this point, if the following operations are carried out, the shaking of the lifting load can be reduced.
 CD1 electric hoist need to pay attention to the six points
 The track must be installed at both ends of the block, because the CD1 type electric hoist often runs back and forth on the I-beam, so that the crane can be derailed to prevent misoperation. There is a height at the ends of the I-  track, a reliable elastic pad or a baffle with rubber blocks, and the I- beam track should not be outdoors. The extension is equipped with rain proof  equipment.
 If the cross-sectional area of the i-rail ground wire is too small or there is no grounding wire, there will be an electric shock when someone touches the hook. Therefore, the I-steel track meets the requirements of the grounding wire. It is required that the grounding wire of i-rail must be connected to flat steel with 4-5mm diameter, bare copper or cross section not less than 25mm, and should be inspecting regularly.
 Use  the limiter and the guide rope correctly. A restrictive tool for lifting the  electric hoist is a limiter. Its function is to prevent the hook from rising  too high or falling too fast to pull out the wire. The rope is mounted on the sleeve of the rope slot and moves in the axial direction of the sleeve, so that  the wire rope is aligned with the sleeve and collides with the stop plate on  the lever, so that the hook is automatically in the limit range to ensure the safe operation of the electric hoist. An indispensable safety accessory for electric hoist is the limiter and guide rope, which can effectively prevent top guard against bad accidents and garbage accidents.
 The maintenance method of steel wire ropes should be correct. When the rope works, oil (must use steel grease or thin oil, cannot use butter) on the top of the rope on the roller or pulley, so that it naturally suck into the rope, which is the correct method of refueling.
 The operation mode should stick to the way of moving. In order to improve the  operator's working conditions, some units move the control box mounted on the hoist to the wall, and the operator can sit on the chair "remote control command", but this way increases the probability of the accident. Therefore, the control box should be installed in the electric hoist which is not too long in the control line so that the operator can move with the gourd when operating at the level, so that the operation of the equipment can be observed at any time, and the accident can be avoided.
 The regular maintenance system is strictly enforced. Electric hoists and other lifting appliances must be regularly maintained according to safety regulations. In addition to regular maintenance (including replacement of  electrical parts), electric hoists should be servicing regularly, and wear parts must be replaced in time. During the overhaul, we must strictly carry out the debugging according to the procedures, and can be put into use after being qualified.

CD1 Electric Wire Rope Hoists manufacturers1-1.jpg

Ramhoist News
  • No information
Ramhoist FAQ