Automatic Driving Motor Full Electric Lithium Battery Pallet truck Forklift With Charger

As a pallet truck driver, you should know these (2)
 7.  What are the maintenance categories of pallet trucks? What are the time intervals?           

 Answer: 

The maintenance of pallet truck trucks can be divided into four categories: daily maintenance, first-class maintenance, second-class maintenance and third-class maintenance. Daily maintenance is a daily maintenance, usually every 50 hours after the first level of maintenance, every 200 hours after the second level of maintenance, every 600 hours after the third level of maintenance.            

 8.  What are the daily maintenance contents of pallet truck trucks?           
 Answer: The specific contents are as follows:           
 (1)  Check the amount of oil in engine crankcase and air filter, the amount of fuel in fuel tank and the amount of cooling water in radiator, add as required when insufficient.           

 (2)  Check the height of the electrolyte level in the battery, add it as needed, keep the blowhole of the lid unblocked, and connect the pole tightly and firmly with the conductor joint.            

 (3)  Check the free travel and working reliability of hydraulic brake and hand  brake, and fill brake fluid and remove air in the system as necessary.            

 (4)  Check the tire pressure and remove impurities embedded in the tread.            

 (5)  Check the amount of oil in the tank of the vehicle hydraulic system, the pipeline and the joints for leakage.            

 (6)  Check the water level of the fire extinguishing tank.            

 (7)  Check the working conditions of instruments, lights, loudspeakers, etc.            

 (8)  After the above checks are completed, start the engine, check the operation of the engine, and check whether the transmission system, brake system and hydraulic lifting system are working properly.            

 9.  What is the main content of the first-class maintenance of pallet trucks?           

 Answer: 

 (1)  Check the amount of oil in the engine, the viscosity of the oil and the dirty degree in the oil.            

 (2)  Clean batteries, add distilled water as necessary.            

 (3)  Check the appearance of fan belt and its tightness.            

 (4)  Check the abnormal noise of gearbox, driving axle, working oil pump and water  pump driving device.            

 (5)  Add oil or grease to all parts of clutch and brake longitudinal connecting rod  as required.           

 (6)  Check the wear condition of piston rod of hoisting cylinder and inclined cylinder. If  there are slight scratch marks, they can be smoothed with oil stone or fine abrasive cloth.           

 (7)  Check and tighten the bolts and nuts of tyres.            

 10.  What are the main contents of the second-level maintenance of pallet trucks?           

 Answer: 

 (1)  Clean engine oil pan, crankcase and oil filter and replace new oil.           

 (2)  Clean the fuel tank and check the connection of the fuel pipeline and pump for loosening and leakage.            

 (3)  Check the power-off contacts of the distributor and adjust the period gap.           

 (4)  Inspecting and tightening bolts at exposed parts of generators.            

 (5)  Check the discharge of the battery and charge it as necessary.            

 (6)  Replace the cooling water in the radiator.            

 (7)  Check and adjust the free travel of clutch and brake pedal and brake clearance of wheel brake.            

 (8)  Discharge the sediment and water at the bottom of the working tank, clean the filter screen and add new oil as appropriate.            

 (9)  Check whether the tightness of the two lifting chains is the same.            

 (10)  Check whether there are deformation and cracking in the iron jam and the heel of the pallet truck.